Satel INTEGRA Plus Especificações descarregar pdf (Página 18)

16 ETHM-1 Plus SATEL

Outputs ON – highlight the outputs which are to be activated (double-click on the field

designated by the output number).

Outputs OFF – highlight the outputs which are to be deactivated (double-click on the field

designated by the output number).

Change outputs state – highlight the outputs whose status is to be changed (double-click

on the field designated by the output number).

KNX telegram – program the following parameters of KNX telegram:

INT-KNX module – INT-KNX module which is to send the telegram.

Group address – the group address which will be inserted in the telegram.

Type – the telegram type.

Value – the value that will be inserted in the telegram (parameter available for some

types of the telegram).

Priority – telegram priority (if two elements of the bus start transmitting simultaneously,

the telegram with higher priority will be sent first).

Exit delay clearing (no additional parameters to configure).

Quick arm – select the arming mode which is to be activated.

The partitions must be controlled by user code.

The zones must not have the BYPASS DISABLED option enabled.

The outputs must be the 24. MONO SWITCH, 25. BI SWITCH, 105. SHUTTER UP,

106. SHUTTER DOWN or REMOTE SWITCH type (they need not be assigned to any group

of outputs).

Using the MOBILEKPD-2 PRO application, you can control the KNX system, if the

INT-KNX module is connected to the control panel.

6.4.3 Defining macro commands

1. Click on the "Read" button to read the macro command related data from the module.

2. Click on the "Definitions" tab.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Sem comentários

Satel INTEGRA Plus Especificações Página 18