Satel INT-KSG Manual do Utilizador descarregar pdf (Página 6)

4 INT-KSG SATEL

4 short beeps and 1 long beep – to signal:

 activating output;

 enabling the chime signal in keypad with the 8 key.

 terminating the function and exiting the user menu, after confirmation of the data

entered.

1 long beep – signaling of:

 violated / bypassed zones when arming

 fault of the vibration detector (10. 24

H VIBRATION

type zone was not violated during the

vibration detector test run upon starting the arming procedure).

2 long beeps – an unknown code, unavailable function, or exiting the function without

confirmation of the data entered (e.g. after using key).

3 long beeps – unavailable function.

Events signaled by sounds

5 short beeps – zone violation (CHIME).

Long beep every 3 seconds, followed by a series of short beeps for 10 seconds

and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only

the final sequence of short beeps will be generated).

A sequence of 7 beeps of diminishing duration, repeated every few seconds –

countdown of auto-arming delay.

2 short beeps every seconds – countdown of entry delay.

2 short beeps every 3 seconds – signaling a new trouble.

Continuous beep – alarm.

Long beep every second – fire alarm.

Only installer selected events are signaled.

Alarms will be signaled as long as programmed by the installer.

2. Arming

This section describes the operations after completion of which the arming procedure begins.

The arming procedure ends simultaneously with the expiry of the exit delay countdown (if the

procedure is ended successfully, the system becomes armed – see also F

AILURE OF ARMING

PROCEDURE

p. 6). If the exit delay time is 0, the system becomes armed instantly.

For additional information on arming, armed modes, etc., please refer to the INTEGRA or

INTEGRA Plus control panel user manual.

2.1 Full arming without partition selection

The arming without selecting partitions is possible, when none of the partitions available to

the user is armed and the keypad is not signaling any alarm.

1. Enter the code and confirm using or .

2. After the A

RM ALL

function has been displayed as the

selected one, touch the

or key. The arming procedure

will be initiated in all partitions which are accessible to the

user and are operated by the keypad.

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Satel INT-KSG Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Teclados numéricos Satel INT-KSG